50
S1 Wheel and Tiller Pilots Commissioning Guide
If you set
AUTOADAPT
to
nth
or
Sth
, you then need to enter your current
latitude in the next screen (
LATITUDE
). If you have a GPS connected, the
SmartPilot will take latitude information from the GPS.
Latitude
The SmartPilot only displays this screen if you have set
AUTOADAPT
to
nth
or
Sth
. Use the
1,+1, 10
and
+10
keys to set the value to your boat’s current
latitude, to the nearest degree.
If valid latitude data is available via SeaTalk or NMEA, the SmartPilot will use this
data instead of the calibration value.
System reset
WARNING: Losing settings at system reset
Do NOT use this feature unless advised to do so by a Raymarine
dealer. If you complete a reset you will lose ALL SmartPilot
calibration settings. You will then need to repeat the SmartPilot
commissioning process.
Selecting System reset will reset all of the calibration values:
• all of the settings in User Calibration, Seatrial Calibration and Dealer Calibra
tion will return to the factory default values
• the settings in Display Calibration will not change, as these are stored in each
individual controller
To reset the system:
1. Select the System reset (
RESET
) screen in Dealer Calibration.
2. Press the
+1
key, then press
AUTO
.
3. The screen will then show an
ARE YOU SURE
message:
• press the
+1
key again to select ‘
YES
’ and reset the SmartPilot
• alternatively, press the
AUTO
key to cancel
4. You will then see the
CAL LOCK
screen:
• press
standby
for 2 seconds to save the new default settings, then turn
the SmartPilot computer power off and back on
Screen Text
Range
LATITUDE
0°
to
80°
in 1° steps
81282_1.book Page 50 Monday, October 2, 2006 1:58 PM
