Chapter 3: Adjusting SmartPilot Settings
39
Note:
It is good practice to keep the
BTW
and
DTW
pages for display. If your SmartPi
lot receives a man overboard (MOB) message, these data pages will show the bearing and
distance to the MOB location.
To change the data displayed on a data page:
1. Press
disp
to move to the appropriate data page setup screen.
2. Use the
1
and
+1
keys to scroll forwards or backwards through the available
data pages (see following table).
3. Then press
disp
to move to the next data page you want to change, or press
and hold
standby
for 2 seconds to save changes.
4
RESPONSE
Remaining pages
NOT USED (These pages are not displayed when you scroll
through the data pages during normal operation)
Available Data Pages
Displayed as
Speed Knots
SPEED KTS
Log
LOG
XXXX.X
Trip
TRIP
XXX.X
Average Speed
AV. SPD
Wind Direction
e.g.
WIND PORT
Wind Speed
WIND KTS
Depth Metres
DEPTH M
see Note below
Depth Feet
DEPTH FT
see Note below
Depth Fathoms
DEPTH FA
see Note below
Heading
HEADING
Water Temperature, Degrees C
WATER °C
see Note below
Water Temperature, Degrees F
WATER °F
see Note below
Course Over Ground
COG
Speed Over Ground, Knots
SOG KTS
Data Page
Default Setting
81282_1.book Page 39 Monday, October 2, 2006 1:58 PM
