Raymarine autopilot, Owner'S Handbook Manual

Page: 92 / 139

Chapter 7: Adjusting Autopilot Settings 79
7
Adjusti
ng Au
to
pil
ot
Setti
ng
s
7.2 Display Calibration
Display Calibration allows you to select the type of bar graph and
heading shown on the display, and control the information
shown on the data pages.
Display Calibration screens
Display bar selection
This screen allows you to select the type of bar graph shown at the
bottom of the display.
Heading selection
This screen allows you to display any heading as either a magnetic or
true value. During normal autopilot operation the screen will indicate
MAG
for magnetic headings and
TRUE
for true headings.
Options
RUDD BAR
Rudder position bar
This is the default setting. It uses the bar graph to show the
true rudder angle. Requires rudder position sensor for
accurate rudder information.
STEER BAR Steer/error bar
This setting uses the bar graph to indicate different
information in different operating modes:
• Standby: rudder position bar
• Auto: heading error bar (in 2° increments)
• Track: cross track error (XTE) bar (in 0.02 nm increments)
• Wind Vane: wind angle error bar (in 2° increments)
BAR OFF No bar displayed.
Options
HDG MAG Magnetic heading.
HDG TRUE True heading.