Raymarine autopilot, Owner'S Handbook Manual

Page: 63 / 139

50 Autopilot Control Unit - Owner’s Handbook
5
Install
ing
the
5.3 SeaTalk connections
The SeaTalk connections on the provide it with its 12 V DC
power supply and allow it to share data with SeaTalk equipment.
Connecting to a course computer
If you are using the as the main control unit for a course
computer autopilot system, connect it directly to the course computer
SeaTalk terminals. To do this:
• cut off the moulded plug at one end of the SeaTalk cable
• strip 5 mm (
1
/
2
in) of insulation from each wire
• then connect to the course computer terminals as shown
Note: If you are connecting the to a course computer
autopilot system that includes other control units, refer to the
information contained in the Autopilot System Installation Guide.
Connecting to SeaTalk
If you are using the as an additional control unit, use a
SeaTalk cable to connect it to another SeaTalk unit as shown.
Connecting to course computer as main control unit
or
control unit (rear)
Type 150/400 course computer terminals
Screen
Red
Yellow
D5500-1
D5501-1
Connecting to SeaTalk as additional control unit
To SeaTalk
power supply
or
control unit (rear)
SeaTalk
unit (rear)