Raymarine autopilot, Owner'S Handbook Manual

Page: 88 / 139

Chapter 7: Adjusting Autopilot Settings 75
7
Adjusti
ng Au
to
pil
ot
Setti
ng
s
Chapter 7: Adjusting Autopilot Settings
This chapter explains all of the calibration settings you can adjust on
the autopilot system. You will have adjusted many of these settings
when commissioning the system (see Chapter 6), and they should not
require further adjustment.
Note: Complete the procedures described in Chapter 6 before
adjusting any calibration settings.
The sections in this chapter provide explain the Calibration mode and
the settings in the 4 calibration groupings:
Note: If you are connecting the to a non-150/400 autopilot
system, the calibration groups are different. Refer to the Appendix for
more information.
7.1
Calibration basics
This explains the structure of the Calibration mode, and
how to access the four calibration groupings.
page 76
7.2
Display Calibration
The Display Calibration grouping allows you to control
the display features (bar graph type and data
page information). This section also explains how to
use data pages to set up the control unit as a remote
control for ST60/ST80 instruments.
page 79
7.3
User Calibration
The User Calibration grouping includes autopilot
settings that you may need to adjust in response to
changing sea conditions.
page 87
7.4
Seatrial Calibration
The Seatrial Calibration grouping is used specifically for
the initial autopilot seatrial (see Chapter 6 for full
details).
page 91
7.5
Dealer Calibration
The Dealer Calibration grouping controls the main
autopilot settings and also the calibration lock.
page 92