![background image](http://html.mh-extra.com/html/raylase/axialscan/axialscan_manual_789726044.webp)
Chapter 5
Installation
44
RAYLASE 3-Axis Subsystems for Laser Beam Deflection
MN025 / v2.1.0
For subsystems with manual field size adjustment only
5.6
Manually adjusting the field size
The 3-axis laser beam subsystem can be adjusted to different field sizes as follows. The field
sizes that can be set are listed in the data sheet. If you want to set a different field size, you
must consult RAYLASE for assistance.
5.6.1
Preparation
o
Load the correction file corresponding to the desired operating field size.
Make sure that you use the following identification code:
AXIALSCAN
The following identification code is used for AXIALSCAN type subsystems:
Type
AS AXIALSCAN
│
Aperture of associated deflection unit [mm]
│ │
Coating code Wavelength [nm] .............. Laser
│ │ DY 532 .............. ........... Nd:YAG
│ │ TY 355 ......................... Nd:YAG
│ │ Y 1064 ......................... Nd:YAG
│ │ C 10600 ........................ CO2
│ │ │
Field size range (min.-max.)
│ │ │ │
Type
│ │ │ │ st standard
│ │ │ │ bo beam optimized
│ │ │ │ hp high power
│ │ │ │ │
│ │ │ │ │ Operating field size
└─ └─ └─ └────────└── └
XX-XX-XX_XXXX-XXXXxxx_XXXX.gcd
FOCUSSHIFTER
1
The following identification code is used for FOCUSSHIFTER type subsystems:
Type
FS FOCUSSHIFTER
│
Aperture of associated deflection unit [mm]
│ │
Coating code Wavelength [nm] .............. Laser
│ │ DY 532 .............. ........... Nd:YAG
│ │ TY 355 ......................... Nd:YAG
│ │ Y 1064 ......................... Nd:YAG
│ │ C 10600 ........................ CO2
│ │ │
Focal distance
│ │ │ │
└─ └─ └─ └──
XX-XX-XX_XXX.gcd
o
Create all electrical connections for the power supply and for control of the 3-axis subsys-
tem (
page 9, Special hazards caused by mirrors made of beryllium).
o
For details of connecting the deflection unit to a RAYLASE control card and operation with
RAYLASE software, refer to the corresponding manuals.
1
In general there are no special correction files for Focusshifter. The standard 2-axis correction files are used.
For using weldMARK in combination with FOCUSSHIFTER a special configuration file has to be generated in order to
compensate for different object sizes at different z-position.