55M4300CCE00 Rev A
*Note 2: The chart file that contains all the relevant load charts and duty information
for the machine also contains dimensions, weights and center of gravity for all the
boom top attachments (fly jibs etc.). In some cases some of this data may not have
been available during the system configuration at the factory. In these cases it will be
necessary to obtain the information by surveying the hardware on site, the attending
Rayco Wylie technician will be equipped to update the load chart file with this data.
In the event of a Rayco Wylie technician not attending please refer to the dimension
sheet and contact Rayco Wylie Systems technical service and provide them with the
missing dimensions and weights. The load chart file will be updated with the verified
information and returned via email. Before calling please take note of the technical
file reference (TF-xxxxx) and serial number located on the serial number label of the
display, alternatively, go to the diagnostics screen, select ‘system’ and note the full
name of the load chart file given there. This will enable our Technical Service
representative to efficiently access all the information about the system.
Base boom geometry
Note sign convention: All dimensions shown positive except
CF
, the centreline of slew is
generally in front of the boom pivot pin in which case
CF
is negative. If any dimension
falls the opposite side of it’s datum line shown in the diagrams then it’s sign will change
eg if the top of the boom lift cylinder is above the centreline of the boom then CL9 will
be negative etc.
Summary of Contents for i4300
Page 2: ...55M4300CCE00 Rev A ...
