55M4300CCE00 Rev A
Step #2: “Enable/Disable i/o” Setting
Note: these settings reflect the configuration of your system and will generally be
made during factory testing prior to delivery and should not need changing.
1- In the calibration menu, scroll up or down to the menu "Enable/Disable i/o".
2- Press
“
”
to enter this menu.
3-
Scroll to select the I/O option to edit.
4-
Press
“
”
to highlight the value to edit. Scroll up or down to change to value
then Press
“
”
to confirm.
5-
Any change made must be permanently registered by pressing the
“save”
button.
6-
Press
“
”
at any time to abandon any changes not saved or to exit the menu
when done.
As a guide, the minimum requirements for a basic system are:
Angle 1
ON
Length 1
ON
Load 1
ON
Load 2
ON
Relay board 1 ON
All remaining items in the list are optional and set to OFF if not used.
Refer to the wiring diagram supplied with your system to determine which I/O should be
enabled, this will be indicated by a table or a notation adjacent to each component. See
example below: (Ref Load 1 and Load 2) means that these two I/O items need to be ON.
Summary of Contents for i4300
Page 2: ...55M4300CCE00 Rev A ...
