Raven AutoBoom 9600, Installation Manual, Page: 43 / 79

4
Manual No. 016-0230-096 37
POWERGLIDE PLUS
INSTALL THE POWERGLIDE PLUS WIRING
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
INSTALL THE AUTOBOOM NODE
FIGURE 15. AutoBoom Node Installed
1. Use the existing holes on one edge of the supplied mounting plate (P/N 107-0171-619) as a guide to drill two 3/
8” holes in the machine’s center rack.
1. Place the AutoBoom node (P/N 063-0130-010) on the supplied mounting plate.
2. Use the AutoBoom node as a guide to mark and drill three 3/8” holes in the mounting plate.
3. Fasten the AutoBoom node to the mounting plate using three 3/8”-16 zinc hex bolts (P/N 311-0054-106) and
three 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).
4. Using the drilled holes, secure the mounting plate to the machine’s center rack using two 3/8”-16 zinc hex bolts
(P/N 311-0054-106) and two 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).
5. Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 or 115-0230-085) into
the correct ports of the AutoBoom node.
6. Tighten the bolts on the node connectors to secure the connections.
CONNECT THE HARNESS TO THE BOOM FUNCTION CONTROLS
1. Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-045 or 115-0230-085).
2. Route the connectors to the AutoBoom valve (P/N 063-0131-126).
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.