Raven AutoBoom 9600, Installation Manual, Page: 25 / 79

3
Manual No. 016-0230-096 19
POWERGLIDE
INSTALL THE GAUGE WHEELS
GAUGE WHEEL MOUNTING LOCATIONS
Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location for
mounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding or
unfolding the booms. The wheels should be mounted outside of the boom fold, but inside of the boom
breakaway.
MOUNT THE GAUGE WHEELS
NOTE: The appearance of the wheel axles may vary, depending on the type of wheel axle kit that was
ordered.
FIGURE 8. Gauge Wheel Installed
1. Remove the lug nuts from the wheel axle.
2. Place the wheel (P/N 322-0131-008) on the wheel axle.
3. Reinstall the lug nuts on the wheel axle to secure the wheel.
4. Mount the receiver bracket (P/N 116-0159-537) to the front of the left boom over the fold cylinder guide tube
using two 5-1/16” W x 6” L x 7/16” thread U-bolts (P/N 107-0171-603) and four 7/16”-16 zinc flanged lock nuts
(P/N 312-1001-165).
5. Insert the wheel axle into the receiver bracket, positioning it so that the bottom of the wheel touches the
ground (or nearly so) and the wheel faces away from the machine.
6. Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2”-13 x 1-1/2” SS hex bolts
(P/N 311-0058-186) and two 1/2”-13 zinc hex nuts (P/N 312-1001-043).
7. Repeat the steps above to install the right wheel.
WARNING
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.