Raritan DOMINION DSX-0N-E, User Manual

Page: 31 / 233

C
HAPTER
3: I
NITIAL
S
OFTWARE
C
ONFIGURATION
13
Network Configuration
1. Click
Network
in the Configuration section of the Setup screen. The Network Configuration
Screen appears.
Note: If you have a dual LAN model, there is an Eth Failover checkbox that is selected by
default, but can be turned off. The screen below represents a single LAN model and does not
show this checkbox.
Figure 11 Network Configuration Screen
Note: Your network administrator usually assigns the values for the following parameters:
2. Type the data in the following fields:
•
IP Address:
Network address for this unit
•
Subnet Mask
: Subnet mask for the network where this unit will reside
•
Gateway IP Gateway:
Default gateway for this unit
3. Select the
Mode
from the Mode drop-down menu.
4. Type the
Domain Name
in the
Domain
field.
5. Type your Unit Name in the
Unit Name
field.
6. In the Ports section:
•
Type
5000
or another port number in the
CSC Port
field.
•
Type
5000
or another port number in the
Discovery Port
field.
7. Click
OK
.
Dominion SX displays either a confirmation or error screen.
1.
Click
OK
when the confirmation window appears. After the confirmation screen, Dominion
SX automatically disconnects to update the configuration then restarts.
2. Remove the crossover cable between the SX unit and your computer.
3. Connect one end of a straight-through Cat 5 cable to the SX.
4. Connect the other end of the cable to the network.
5. Use the newly assigned IP Address to access your SX unit.