R&S NRX Series, User Manual

Page: 63 / 514

Configuration for All Measurement Types
R&S
®
NRX
63 User Manual 1178.5566.02 ─ 07
"Auto" Automatically starts a measurement if no trigger event has occurred
after 300
ms.
Remote command:
TRIGger<undef>:ALL:MODE
on page 225
TRIGger<Measurement>:MODE
on page 225
Trigger Source
For primary and secondary power sensors.
Sets the source for the trigger event. See Chapter 6.3.2, "Trigger Sources" ,
on page 60.
Remote command:
TRIGger<undef>:ALL:SOURce
on page 227
TRIGger<Measurement>[:CHANnel<Channel>]:SOURce
on page 227
Trigger Level
For primary and secondary power sensors.
Sets the trigger threshold for internal triggering derived from the test signal.
The trigger level is displayed as dotted red line. The trigger time is displayed as small
rhomb on the trigger level line.
Remote command:
TRIGger<undef>:ALL:LEVel
on page 224
TRIGger<Measurement>[:CHANnel<Channel>]:LEVel
on page 224
Trigger Advanced
For primary and secondary power sensors.
Groups further trigger settings.
Source ← Trigger Advanced
See "Trigger Source" on page 63.
Slope ← Trigger Advanced
Determines which edge of the envelope power (internal triggering) or increasing volt-
age (external triggering) is used for triggering.
"Positive" Rising edge
"Negative" Falling edge
Remote command:
TRIGger<undef>:ALL:SLOPe
on page 226
TRIGger<Measurement>[:CHANnel<Channel>]:SLOPe
on page 226
Level ← Trigger Advanced
See "Trigger Level" on page 63-
Delay ← Trigger Advanced
Sets the delay between the trigger event and the beginning of the actual measurement.
Triggering
www.allice.de Allice Messtechnik GmbH