Rain Bird WS-PRO, Installation, Maintenance And Troubleshooting Manual

Page: 41 / 78

Page
31
CONFIGURE SENSOR SWITCH
SETTINGS:
Refer to FIGURE 16 below:
The Sensor Switches are located on the
ET Enclosure panel just below the
modem and to the right of the the “Heat
Sink” located to the right of the battery
connectors. These switches or pots
need to be set as indicated in FIGURE
16 below.
FIGURE 16 - SENSOR SWITCH SETTINGS
SHORT HAUL MODEM
INSTALLATION
Refer to FIGURE 18 below: (PRO-SH)
The Short Haul Modem, at the weather
station, is normally installed at the
factory in the ET Enclosure. The Short
Haul Modems enable communication
between the datalogger and the central
computer over two (2) twisted pairs of
wires. The maximum distance between
modems is determined by the baud rate
and the wire gauge. At 9600 baud, the
approximate range is 4.0 miles. DCE/
DTE switches on the modems must be
set to DCE.
INSTALLATION:
For installation of the Short Haul RAD
Modem inside the Enclosure, the
following components are provided in
the Short Haul modem kit:
SC932C Interface w/ribbon cable
RAD Modem
RAD/SC932C Mounting Bracket
Velcro Mounting Strap w/Buckle
Mounting Screws
12 inch 4-wire Patch Cable
Partially install three (3) of the furnished
screws in the holes on the left side of the
Enclosure housing for the datalogger.
Hold the Modem mounting bracket in
the position it will be in the Enclosure.