© Raimondi S.p.A.
Page 19/36-4
Use and Maintenance Manual
CHAPTER 4
Use of the Commands
raimondispa.com
Via dei Tipografi 11, 41122 Modena (MO) - Italy
Tel.: +(39) 059 280888 - Fax: +(39) 059 282808
The maximum length of the cut can be obtained as follows:
1.
Bring the motor group to the beginning of the cut and at the maximum rise position.
2.
Get into the material from above, like when using a cutting-off machine.
3.
When the low position has been reached, advance with the blade to make a complete cut.
Cut
Cutting-off machine cut
BOLT 150
tiles size
0 - 135 mm (5
5/16”
)
135 mm (5
5/16”
) - 150 mm (5
29/32”
)
BOLT 120
tiles size
0 - 105 mm (4
9/64”
)
105 mm (4
9/64”
) - 120 mm (4
23/32”
)
BOLT 90
tiles size
0 mm - 75 mm (2
61/64”
)
75 mm (2
61/64”
) - 90 mm (3
35/64”
)
4.2 Diagonal cuts
Slacken the lever (
A
) and position the square (
B
) at 45°, tighten the lever (
A
).
Slacken the lever (
C
) and position the triangle (
D
) as indicated by the mark on the millimeter bar (diagonal) placed on the square
(
E
).
While keeping the blade above the surface of the tile, let the motor group slide and
perfect,
varying the inclination of the
square (
B
), the position
thereof so that the blade at the beginning and at the end of the cut matches the vertexes
of the tile. Once this has been achieved, tighten the
lever (
A
) completely, place the triangle (
D
) close to the edge of the tile and tighten the lever (
C
) completely.
A
B
C
D
D
E
IN CASE OF CUTS WITH INCLINATIONS OTHER THAN 90° AND 45°, THE CUTTINg LINE SHALL BE DRAWN ON
THE TILE.
WITH MOTOR TURNED OFF, PLACE THE TILE ONTO THE MACHINE BENCH, LET THE BLADE SLIDE OvER THE TILE,
MAKINg SURE THE CUTTINg LINE MATCHES THE LINE PREvIOUSLY DRAWN ON THE TILE.
APPROACH THE TRIANgLE (D) TO THE TILE EDgE AND BLOCK IT BY TIgHTENINg THE LEvER (C).
