© Raimondi S.p.A.
MANUALE D’USO E MANUTENZIONE
PAG.X DI XX
mod. BOLT - ED. 03/2015 - S. 01
Page 20/36-4
CHAPTER 4
Use of the Commands
raimondispa.com
Via dei Tipografi 11, 41122 Modena (MO) - Italy
Tel.: +(39) 059 280888 - Fax: +(39) 059 282808
4.3 45° Jolly cuts
Slacken the uprights locking knobs (
A
) (front and rear), tilt the sliding bar (
B
) to the end of travel and block it by firmly screwing the uprights
locking knobs (
A
).
BRINg THE MOTOR gROUP TO MAXIMUM HEIgHT POSITION.
Lower the motor head so that the diamond blade rim is at the same height of the work bench and
block it by tightening the knob (
C
) completely.
A
B
BEFORE TILTINg THE SLIDINg BAR, MAKE SURE THE DIAMOND BLADE DOES NOT HIT THE MACHINE FRAME AND
THE MATERIAL TO BE BEvELED.
C
Place the tile to be beveled with glaze side turned upwards on the work bench , making sure it is perfectly resting on the square (
D
). Visually
check the diamond blade is at the level of the glaze. Approach the triangle (
E
) to the tile and block it by means of the lever.
Make a 2/3 cm (25/32”) / (1
11/64”
) test jolly cut to verify it is at glaze level, if needed, after slackening the blocking lever of the triangle (
E
)
perfect the positioning of the tile. Once the desired positioning has been achieved, approach the triangle (
E
) and block it by tightening the lever.
BEFORE MAKINg CUTS, MAKE SURE THE UPRIgHT LOCKINg KNOB (A) AND MOTOR LIFT LOCKINg KNOB (C)
HAvE BEEN SCREWED COMPLETELY.
D
E
