© Raimondi S.p.A.
MANUALE D’USO E MANUTENZIONE
PAG.X DI XX
mod. BOLT - ED. 03/2015 - S. 01
Page 10/36-2
CHAPTER 2
Safety Rules
raimondispa.com
Via dei Tipografi 11, 41122 Modena (MO) - Italy
Tel.: +(39) 059 280888 - Fax: +(39) 059 282808
2.6 Position of the operator
The BOLT series shall be used by one single operator, who will
have to stand in front of the machine and, by grabbing the
ergonomic handle, will be able to make cuts in safe conditions
and unstressfully.
During the working phase, the operator shall always stand in
the front part and grab the handle with one hand, while the
other hand holds the material to be cut over the work bench.
The material shall always be leaned against the reference square.
CUTTINg DANgER
THE MACHINE SHALL BE TURNED ON EXCLUSIvELY WHEN THE OPERATOR IS IN THE WORKINg POSITION. THE
MACHINE SHALL BE TURNED OFF AT THE END OF EACH CUTTINg OPERATION.
gETTINg THE HANDS CLOSE TO THE CUTTINg BLADE WHEN IT IS RUNNINg IS STRICTLY FORBIDDEN
.
2.7 Safety devices
The BOLT series is equipped with the following safety devices:
1 ON/OFF switch
It allows for the start and stop of the machine. In case of potential danger, the machine shall
be turned off by means of the red OFF switch.
2 Splash guards
It prevents water and debris, caused by cutting, from reaching the operator. The brushes of the
guards are subject to wear and shall be replaced at regular intervals.
Another safety device is represented by the electric supply plug, which, in case of danger, will
have to be immediately disconnected.
RAIMONDI S.P.A. WILL NOT BE HELD RESPONSIBLE FOR DAMAgE CAUSED BY EJECTIONS RESULTINg FROM SCARCE
MAINTENANCE OF OR TAMPERINg WITH THE gUARDS, OR FROM AN ERRONEOUS POSITION OF THE OPERATOR
(SEE PICTURE SHOWINg THE POSITION OF THE OPERATOR).
2.8 Accessories of the machine
The BOLT series is supplied with the following accessories:
1. 30 mm (1
3/16”
) hexagon wrench.
2. 4 mm (5/32”) and 8 mm (5/16”) socket head screw.
3. Dressing stone.
4. Use and maintenance manual in the relative language.
1
2