WPA/WPA2 mixed mode
WPA2 should be preferred over WPA1, running WPA/WPA2 mixed-
mode offers both.
WPA cipher
The WPA cipher to be used, the default is to run both (TKIP and
CCMP).
Identity
The identity used for WPA-RADIUS and WPA-EAP-TLS.
Passphrase
The passphrase used for authentication with WPA-PSK, otherwise
the key passphrase for WPA-EAP-TLS.
Force PMF
Enables Protected Management Frames.
You can perform a WLAN network scan and pick the settings from the discovered information directly.
The authentication credentials have to be obtained by the operator of the remote access point.
WLAN IP Settings
This section lets you configure the TCP/IP settings of your WLAN network.
A
client
interface can be run over DHCP or with a statically configured address and default gateway.
The
access point
networks can be bridged to any LAN interface for letting WLAN clients and Ethernet
hosts operate in the same subnet. However, for multiple SSIDs we strongly recommend to set up
separated interfaces in routing-mode in order to avoid unwanted access and traffic between the inter-
43
© RACOM s.r.o. – MG102iGPRS/UMTS/HSPA+/LTE router
Web Configuration
Summary of Contents for MG102i
Page 2: ......
Page 147: ...147 RACOM s r o MG102iGPRS UMTS HSPA LTE router Web Configuration...
Page 174: ...174...
