The following mobile settings are required:
Modem
The modem to be used for this WWAN interface
SIM
The SIM card to be used for this WWAN interface
Preferred service
The preferred service type
Please note that these settings supersede the general SIM based settings as soon as the link is being
dialed.
Generally, the connection settings are derived automatically as soon as the modem has been registered
and the network provider has been found in our database. Otherwise, it will be required to configure
the following settings:
Phone number
The phone number to be dialed, for 3G+ connections this commonly refers
to be *99***1#. For circuit switched 2G connections you can enter the fixed
phone number to be dialed in the international format (e.g. +420xx).
Access point name
The access point name (APN) being used
Authentication
The authentication scheme being used, if required this can be PAP or/and
CHAP
Username
The username used for authentication
Password
The password used for authentication
Further on, you may configure the following advanced settings:
Required signal strength
The minimum required signal strength before the connection is
dialed. It can be specified as the RSSI level in dBm units, or as the
Quality level in percent. See the "more info" button to see the exact
values.
Home network only
Determines whether the connection should only be dialed when
registered to the home network.
Negotiate DNS
Specifies whether the DNS negotiation should be performed and
the retrieved name-servers should be applied to the system.
37
© RACOM s.r.o. – MG102iGPRS/UMTS/HSPA+/LTE router
Web Configuration
Summary of Contents for MG102i
Page 2: ......
Page 147: ...147 RACOM s r o MG102iGPRS UMTS HSPA LTE router Web Configuration...
Page 174: ...174...
