Raco AlarmAgent.com AA-102DC, Installation Manual

Page: 13 / 43

12
7.0 Signal Wiring Connections
Refer to the signal wiring diagrams in Appendix D which are included
independently for each specific Application Template.
For optional analog input wiring connections, as well as connections for
relay outputs and optional remote Arm/Disarm module, refer to
Appendix E.
8.0 Preliminary Local Configuration of the RTU
Virtually all configuration operations can be done remotely from the web site
(http:// www.alarmagent.com ).
However, there are two simple configuration steps which we strongly suggest doing at the RTU.
Step 1: Set the Application Template
After determining the correct Application Template from the above information, locate the four-position
DIP switch on the left hand edge of the circuit board. Refer to the diagram. With the RTU turned on,
set the Application Template according to the following diagram:
Note:
Be sure that the
digital inputs are non-
powered (dry) contacts;
otherwise the RTU may be
damaged.