© Copyright Qvis ®. All documentation rights reserved.
36
to exit current setup. Do remember click save button to save current setup. If you click ESC
button to exit the region setup interface system will not save your zone setup.
Sensitivity:
System supports 6 levels. The sixth level has the highest sensitivity.
Period:
Click set button, you will seean interface is shown as in Figure 4-25.Here you can
set motion detect period. System only enables motion detect operation in the specified
periods. It is not for video loss or the camera masking. Please select Sunday to Saturday
from the dropdown list. You will seethere are six periods for you to set. Please note you need
to check the box before the period to enable the period setup valid. In Figure 4-25, select
work day or non-work day from the drop down list, and then click the Set button, you can set
your own business day and non-business day setup. See Figure 4-26. You can set Monday
to Friday as the working day and Saturday and Sunday as non-business day. Click Save
button to go back to previous interface.
Anti-dither:
System only memorizes one event during the anti-dither period. The value
ranges from 5s to 600s.
Alarm upload
: System can upload the alarm signal to the network (including alarm centre) if
you enabled current function.
Send email:
System can send out email to alert you when alarm occurs.
Show message:
System can pop up a message to alarm you in the local host screen if you
enabled this function.
Record channel:
System auto activates motion detection channel(s) to record once an
alarm occurs. Please make sure you have set MD record in Schedule interface(Main Menu-
>Setting->Schedule) and schedule record in manual record interface(Main Menu-
>Advanced->Manual Record)
PTZ activation:
Here you can set PTZ movement when an alarm occurs. Such as go to
preset, tour &pattern when there is an alarm. Click
“
select
”
button, you will seean interface is
shown as in
X305H305H305H
Figure 4-24
X
.
Record Delay:
System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Tour:
Here you can enable tour function when alarm occurs. System one-window tour.
Please go to chapter 5.3.6 Display for tour interval setup.
Snapshot:
You can enable this function to snapshoot image when an motion detect alarm
occurs.
Buzzer:
Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Test:
Click it to test current motion detect setup (do not need to save). Click Select button
after Region, you can set motion detect area. The default setup is whole region. The blue
zones are the selected area. Please set sensitivity and click Test button, you will seesystem
only display motion detect status of the blue area. The red flashing area is current motion
detect. See Figure 4-28.
Please highlight icon
to select the corresponding function. After all the setups please click
Save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video
in each channel may not be the same.
Summary of Contents for Izeus hdcvi dvr
