quiko WINNY LIGHT, Installation Manual

Page: 20 / 56

20
19 - PROGRAMMING SELECTOR
The digital function selector can be installed on the side upright of the frame or in the immediate
vicinity of the door
The selector has two keys,
“up/down”
and
“enter”
. They can be used to change operating settings.
There is a hole for initial parameter programming ( reset ), and an LCD display that signals the
selected setting or any possible problems.
To choose the desired function, the user must:
-
Press the “enter” key for one second until the first operating
status appears
- Change parameters using the key “up/down”
- Once the desired function is located, it is confirmed by
pressing the key
“enter”.
The following functions can be selected:
NI
Night This disables the opening commands of the Int/Ext radar, it is
activated only with the OPEN KEY, the door is closed and locked
if there is an electromechanical lock.
MA
Manual This frees travel of the doors so they can be manually opened, such as
for cleaning or to check that they slide correctly. It is deactivated by
pressing the key “up/down” of the selector.
SA Always open The door is always open. This function is deactivated by pressing the
key “up/down” on the selector.
AU Automatic The door can be opened by the impulse devices (radar, buttons, etc.).
AP
partial opening The door can be opened partially using the impulse devices (radar,
buttons, etc.).
RI
Internal radar The door can be opened by the internal impulse devices (radar,
buttons, etc.).
You can lock operation of the digital keyboard by pressing and holding both for 10 sec. the ENTER
and UP/DWN key the set operating status will be shown flashing press and hold both buttons until
the operating status is once again displayed steady and no longer flashing
To unlock the keyboard, repeat the previous step