quiko WINNY LIGHT, Installation Manual

Page: 9 / 56

9
E
N
G
L
I
S
H
6 - PREPARING FOR INSTALLATION
To ensure correct assembly, certain preparations for
installation must be made. The crosspiece must be
attached to a straight surface that is suitable to support the
weight of the doors that will be used. If the wall or
support to be used do not meet these requirements, a
suitable steel tubular structure will need to be provided,
since the crosspiece is not self-supporting.
You should use a level when installing the crosspiece.
Fasten the crosspiece to the wall or support using M6
steel inserts or equivalent. Make sure that the thickness of
the head of the screw is not greater than 8 mm.
The fastening points provided in the crosspiece must be
respected. When drilling and fastening, use care not to damage the sliding track. When fastening is
complete, carefully clean the sliding track to ensure the automation operates correctly.
7 - TABLE OF MATERIAL OF FASTENING SURFACE
Fastening surface materials Minimum thickness Type of screw
Iron 5 mm M8
Aluminium 6 mm M8
Aluminium 3 mm Threaded inserts M8
Reinforced concrete >120 mm at the thinnest point Plugs Ø 14mm Screw TE M8
Plasterboard panel/Perforated Reinforcement required 5mm iron sub-structure
Solid wood 50 mm Log bolt screws TE13mm
Ø8mm
8 - STANDARD INSTALLATION
Height of automation fastening from floor to underside of beam:
Total height of door, including Quiko upper adaptor (22 mm) and Quiko
lower track (30 mm)
+ 8 mm from lower clearance of door
+ 27mm (space between adaptor and beam, adjustable ± 10mm)
See drawing on page 7
9 - INSTALLATION WITH ANTI-PANIC SYSTEM
Height of automation fastening from floor to underside of beam:
Total height of door including Quiko adaptor (60 mm)
+ 15 mm from lower clearance of door
+ 27mm (space between adaptor and beam, adjustable ± 10mm)
See drawing on page 6