Configuring the Routing Table
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 94
To edit a default route:
1. In
Device
>
Internet
, click the Internet connection.
2. Click
Edit
.
The
Edit Internet Connection
window opens in the
Configuration
tab.
3. Set the
Default gateway
(next hop) to a different IP address.
4. Click
Apply
.
When no default route is active, this message shows: "Note - No default route is configured. Internet
connections might be down or not configured."
For Internet Connection High Availability, the default route changes automatically on failover (based on the
active Internet connection).
When a network interface is disabled, all routes that lead to it show as
inactive
in the routing page. A route
automatically becomes active when the interface is enabled. Traffic for an inactive route is routed based on
active routing rules (usually to the default route).
The edit, delete, enable, and disable options (on the
Device
>
Local Network
page) are only available for
manually defined routing rules created on this page. You cannot edit, delete, enable, and disable routing
rules created by the operating system for directly attached networks or rules defined by the dynamic routing
protocol.
To edit an existing route:
Select the route and click
Edit
.
To delete an existing route:
Select the route and click
Delete
.
To enable or disable an existing route:
Select the route and click
Enable
or
Disable
.
