81
also be configured with this command. The configurable range for the UDP port 1 to 65535 (Default is
60000).
(QCT) (if-vlan100)#ip address 192.168.0.2 255.255.255.0
(QCT) (if-vlan100)#exit
c. Configure the keepalive source and destination IP address.
(QCT) #config
(QCT) (Config)#mlag peer-keepalive destination 192.168.0.1 source 192.168.0.2
d. Configure the DCPDP transmission interval and reception timeout values (optional).
(QCT) (Config)#mlag peer detection interval 600 timeout 2000
e. Enable Peer Detection mode. The mode starts running if MLAG is globally enabled.
(QCT) (Config)#mlag peer detection enable
12.
Configure a Port-channel as MLAG interface. The configurable range for the MLAG ID is 1 to 63.
(QCT) (Config)#interface range 0/3-0/6
(QCT) (Interface 0/3-0/6)#channel-group 2 mode active
(QCT) (Interface 0/3-0/6)#exit
(QCT) (Config)#interface range 0/7-0/10
(QCT) (Interface 0/7-0/10)#channel-group 3 mode active
(QCT) (Interface 0/7-0/10)#exit
(QCT) (Config)#interface port-channel 2
(QCT) (if-port-channel ch2)#switchport allowed vlan add tagged 1-99
(QCT) (if-port-channel ch2)#switchport acceptable-frame-types tagged
(QCT) (if-port-channel ch2)#mlag 1
(QCT) (if-port-channel ch2)#exit
(QCT) (Config)#interface lag 3
(QCT) (if-port-channel ch3)#switchport allowed vlan add tagged 1-99
(QCT) (if-port-channel ch3)#switchport acceptable-frame-types tagged
(QCT) (if-port-channel ch3)#mlag 2
(QCT) (if-port-channel ch3)#exit
The administrator must ensure that the port channel configurations on both devices are in sync before
enabling MLAG. After the MLAG interfaces are enabled, the MLAG interfaces are operationally shut down.
The MLAG component exchanges information regarding the port members that constitute the Port-channel
on each device. Once this information is populated on both devices, the MLAG interfaces are operationally
up and traffic forwarding on MLAG interfaces is allowed. Port-channels must be configured on both devices
as MLAG interfaces for the MLAG interface to be enabled. Also, the port-channel-number: MLAG-Id pair
must be the same on both the primary and secondary devices.
Member ports can be added or removed from the MLAG interface. If a port is added as a port member to a
MLAG interface, the Primary allows the port member if the maximum criteria is satisfied. When a port
Summary of Contents for QuantaMesh QNOS5
Page 1: ...QuantaMesh Ethernet Switch Configuration Guide QNOS5 NOS Platform ...
Page 209: ...209 Table 7 8 IPv6 Neighbor Discovery Settings ...
Page 226: ...226 Table 8 2 L3 Multicast Defaults ...
Page 254: ...254 Appendix A Term and Acronyms Table 9 5 Terms and Acronyms ...
