Quanta Cloud Technology QuantaMesh QNOS5, Configuration Manual

Page: 42 / 256

42
To manually configure the IPv6 address, subnet mask, enter:
(QCT)(config)#interface vlan 1
(QCT)(if-vlan 1)#ipv6 address address / prefix-length [eui64]
To view the In-Band management information, enter:
show ip interface.
show ipv6 interface
To save these changes so they are retained during a switch reset, enter the following command:
copy running-config startup-config
2.2.2. DHCP Option 61
DHCP Option 61 (client Identifier) allows the DHCP server to be configured to provide an IP address to a switch
based on its Media Access Control (MAC) Address or an ID entered into the system. DHCP servers use this
value to index their database of address bindings. This value is expected to be unique for all clients in an
administrative domain. This option allows the system to move from one part of the network to another
while maintaining the same IP address.
DHCP client Identifier (Option 61) is used by DHCP clients to specify their unique identifier. The client
identifier option is optional and can be specified while configuring the DHCP on the interfaces. DHCP Option
61 is enabled by default.
2.2.2.1. Configuring DHCP Option 61
Configuring the DHCP with client-id (option 61) differs depending on the port or interface. Refer to
the information below:
Service Port:
To enable DHCP with client-id (option 61) on from the service port, issue the following command:
(QCT) #serviceport protocol dhcp client-id
In-Band management Port:
To enable DHCP with client-id (option 61) on from the In-Band management port, issue the following
command:
(QCT) (Config)#interface vlan 1
(QCT) (if-vlan1)#ip address dhcp client-id
Routing Enabled Interface:
To enable DHCP with client-id (option 61) on from on the routing enabled interface, issue the following
command