Quanta Cloud Technology QuantaMesh QNOS5, Configuration Manual

Page: 228 / 256

228
Switch A. STP is configured on the ports that connect the switch to other switches. OSPF is configured to route
unicast traffic between the VLANs.
To configure the switch:
1. Create two VLANs and configure them as routing VLANs.
(QCT) (Config)#vlan database
(QCT) (Vlan)#vlan 10,20
(QCT) (Vlan)#exit
(QCT) (Config)#interface vlan 10
(QCT) (Config)#interface vlan 20
2. While in VLAN Database mode, enable IGMP snooping on the VLANs.
(QCT) (Vlan)#set igmp 10
(QCT) (Vlan)#set igmp 20
(QCT) (Vlan)#exit
3. Add VLANs to interfaces 0/23 and 0/24.
(QCT) (Config)#interface 0/23
(QCT) (Interface 0/23)#switchport allowed vlan add 10
(QCT) (Interface 0/23)#switchport native vlan 10
(QCT) (Interface 0/23)#switchport allowed vlan remove 1
(QCT) (Interface 0/23)#exit
(QCT) (Config)#interface 0/24
(QCT) (Interface 0/24)#switchport allowed vlan add 20
(QCT) (Interface 0/24)#switchport native vlan 20
(QCT) (Interface 0/24)#switchport allowed vlan remove 1
(QCT) (Interface 0/24)#exit
4. Enable routing on the switch and configure the OSPF router ID.
(QCT) (Config)#ip routing
(QCT) (Config)#router ospf
(QCT) (Config-router)#router-id 3.3.1.1
(QCT) (Config-router)#exit
5. Configure VLAN 10 as a VLAN routing interface and specify the OSPF area. When you assign an IP
address to the VLAN, routing is automatically enabled.
(QCT) (Config)#interface vlan 10
(QCT) (if-vlan10)#ip address 192.168.10.4 255.255.255.0
(QCT) (if-vlan10)#ip ospf area 0
6. Enable IGMPv2 and PIM-SM on the VLAN routing interface.
(QCT) (if-vlan10)#ip igmp