Remove both screws to release
the library from the rack
Flange
Figure 5-32 Removing the screws that secure the Library to the Rack (RLS-85XX shown)
14.
Slide the library out on the rack rails until about 8 inches is sticking out the
front of the rack posts.
15.
The front hand holds must be installed on the library before it can be slid all the
way out of the rack. Please contact Qualstar Technical Support for a replacement
set if the front hand holds that originally shipped with the RLS cannot be
located. Use a Number 2 Phillips screwdriver to install the two screws that
secure the hand holds to the left and right sides of the RLS.
511000 Rev. F
Installation 5-29
