Sequential Operation
511000 Rev. F
nger control. The changer
to
11.2.2
Sequential or Recycl
ots (LD01
to LD15). It was created by using the Partition Items page under Configuration.
on 2
a different partition and white
Sequential
The tape drive allocated to this partition is dedicated to
receiving cartridges under cha
will not perform host-requested cartridge movements
this device.
e Configuration Example
In the following example partition 2 has been configured to contain a single drive (T1),
two slots from the left side I/O port (ld01, ld02) and a column of magazine sl
Touching the Edit button allows for any available elements to be assigned to a
partition simply by touching them. In Figure 11-3 the elements assigned to Partiti
are shown in green, gray elements are assigned to
elements are unassigned.
3 Sequential or Recycle Configuration Example
Dual Bin Configuration Example
In the following example partition 3 has been configured to contain a single dual bin
drive (T3), two slots from the left side I/O port (ld01, ld02) and two columns of
magazine slots. In this case column RB01 to RB15 is the source cartridge location a
column RC01 to RC15 is the destination location.
It was created by using the Partition Items page under Configuration. Touching the
Edit button allows for any available elements to be assigned to a partition simply by
Figure 11-
11.2.3
nd
ce elements assigned to Partition 3 are shown
yellow, gray elements are assigned to a
different partition and white elements are unassigned. Under dual bin configuration
touching them. In Figure 11-4 the sour
in green, the destination elements are
touching an available tape cartridge storage element will cycle it between its three
11-4
