quadient DS-200iQ, User Manual, Page: 84 / 130

78
JUN 2020
USER GUIDE
5 OPERATOR INSTRUCTIONS DS-200iQ / DS-600iQ
REV 00
3. Make any necessary adjustments as required. Depending upon which unit is
selected, the available options for fine tuning are as follows:
Collating
▪ Collate Pkt. Adj (0.1mm) - Adjusts the width of collate pocket guides in
increments of 0.1mm.
▪ Adjust Pawl Pause Pos - Adjusts the pause time after each insertion
Increase the number if pawls start before previous pack has cleared.
▪ Collate Slowdown - Select ‘ Not on Last Form ’ for thick packs if the final
document in the pack does not feed fully into the collate pocket.
Envelope Insertion
▪ Fingers Adj (0.1mm) - Adjusts the overall width of insert fingers in increments
of 0.1mm.
▪ Adjust Envelope Stop (mm) - Adjusts the stop position for insertion.
Select ‘ + ’ to adjust towards the exit in increments of 1mm.
▪ Finger Sequence - Adjust accordingly if envelopes are not opening properly.
▪ Insert in Env Position (mm) - Adjusts the pack insertion into the envelope.
Select ‘ + ’ to adjust past the envelope flap crease in increments of 1mm.
▪ Envelope Blower - Adjusts the opening of the envelope.
Select ‘ High ’ for thick packs, or ‘ Low ’ for single sheets or thin packs.
Wetting and Sealing
▪ Seal Time (ms) - Adjusts the time (ms) the envelope ejects after sealing.
▪ Adjust Wetter Start (mm) - Adjusts where the wetter beam starts.
Select ‘ + ’ to adjust the start point towards insertion area in increments of 1mm.
▪ Adjust Env Seal Pos (mm) - Adjusts the seal position of the envelope.
Select ‘ + ’ to adjust the position of the envelope further in towards the seal rollers in
increments of 1mm.
▪ Adjust Env Reverse Pos (mm) - Adjusts the envelope forward travel after
wetting, before reversing into sealing rollers.
NOTE:
High-windowed envelopes should be set b20mm to +50mm.
Select ‘ + ’ to adjust the envelope further into output rollers, towards the exit in
increments of 1mm.
Miscellaneous
▪ Linear Speed - Adjusts the speed of the Insert Head to the filled envelope
path only.
Select a lower speed if packs are not being fully inserted (e.g. long packs)
▪ Env Conveyor Drive Delay - Adjusts the time delay of envelopes on the
conveyor before the conveyor switches back on.
Select a higher number if envelopes are ‘bunching’.
4. Press ‘ Ok ’ once the desired settings have been made.
5.2.2 INSERT HEAD HOPPER FINE TUNING
1. Select the Insert Head Hopper document on the Run Screen GUI to open the
fine tuning dialog box options as shown in Figure 5.41.
QTL-RND-SCR-00000099-A-00
Figure 5.41 – Insert Head hopper fine tuning
2. Make any necessary adjustments as required. The available options for fine
tuning the Insert Head hopper document are as follows:
▪ Seal Mode - Adjusts the seal mode of envelopes.
Select ‘ Off ’ if manual or later hand insertion is required.
▪ Deskew - Adjusts the skew of documents.
If skewing occurs, select ‘ Low ’ if possible, select ‘ High ’ setting only if necessary.
▪ Wetter Pump On/Off - Turns the Wetter Pump ‘On’ or ‘Off’.
Switch pump ‘ On ’ for few seconds if wetter tank has dried out - Wetter tank will
automatically refill in normal use.
3. Press ‘ Ok ’ once the desired settings have been made.