QRP Labs QCX-mini, Assembly Instructions Manual

Page: 91 / 133

Place the front of the enclosure face down
on the bench as shown, and prepare to
attach the main board. Align the 2x5-pin header connector between
the main and display boards; some wriggling
will be needed to get the controls to fit
through the holes in the front panel.
Fit four M3 6mm nylon screws in the
positions shown This is how it looks from the DC connector
end
Determine correct orientation of the bottom
half of the enclosure; note the tongue-and-
groove arrangement which means that the
bottom half only fits one way round! Make
sure you have the correct way. Now bolt the left-hand side panel to the
enclosure extruded top and bottom halves
using four of the supplied small black
countersunk screws in the panel corners.
The screws need to be carefully aligned and
should screw in easily (if properly aligned).
QCX-mini assembly Rev 1.05_Fr
91