!
)
$
" ##
#$"
!"!
1
In the Operator Control/Media/For MPT Tray select Thick
Stock.
2
In the Operator Control/Outputbin menu select Face-Up.
3
Open the flaps.
Caution:
Do not seal
envelopes before printing.
4
Flex the envelope stack (including the edges) to remove any
stiffness.
Tape must not be present on the adhesive part of the envelope.
5
Place the envelopes on a flat surface, and flatten them by
pressing down the corners.
6
Adjust the multipurpose tray
media guide to the width of
the envelopes.
7
Separate each envelope immediately (before it cools) after
the envelope is delivered to the face-up tray.
»
Note:
Because the envelopes pass through heated rollers, the
gummed area on the flaps may seal to other flaps in the tray
otherwise. Using envelopes with emulsion-based glue avoids this
problem.
