QMS 1800409-001A, User Manual

Page: 153 / 436

Administration/Engine/Image Alignment
The Image Alignment option allows you to adjust the horizontal
and vertical placement of printed images. To check image
alignment, print a standard status page (this option is located in the
Administration/Special Pages menu). When the printer is placing
images properly, the alignment tickmarks at the lower left of a
status page are 0.5"/12.7 mm from the left and bottom edges of the
page. If the tickmarks are off, use this option to align the image
horizontally and vertically in pixel increments (
1
⁄
300
" or .08 mm),
from 000 to 300 pixels (300 pixels = 1" or 25.4 mm). The factory
default setting is 100. Values above 100 move the image to the right
(for horizontal alignment) or down (for vertical alignment); values
below 100 move the image left (for horizontal alignment) or up (for
vertical alignment). See “Entering Alphanumeric Values,” earlier
in this chapter, if you’re not sure how to enter a number in the
message window.
NOTE: Engine constraints may limit the accuracy of pixel
alignment.
Administration/Engine/Default Paper
Default Paper specifies a media size for the printer to use if it does
not recognize the size specified for a job. The choices are letter and
A4. The factory default is letter. Change the default to A4 if you
print on metric-size media.
Administration/Engine/Inputbin 1 Name
Use this option to assign a name to the standard paper cassette
(input bin). For example, you may want to name it “Letterhead” if
you always keep letterhead paper in that cassette. The factory
default is upper.
Administration/Engine/Inputbin 2 Name
Use this option to assign a name to the optional lower cassette (input
Chapter 4
P r i n t e r C o n f i g u r a t i o n 4 - 4 7