QMS 1800409-001A, User Manual

Page: 199 / 436

around your eyes; it can cause respiratory problems and eye
irritation.
ACHTUNG!
Bei dem Entwickler handelt es sich um ein ge-
fährliches und leicht entzündliches Pulver; es darf deshalb
niemals mit offenem Feuer in Berührung kommen. Einatmen
oder Berührung mit Haut und Augen ist ebenfalls zu ver-
meiden, da dies zu Beeinträchtigungen der Atemwege, Haut-
oder Augenreizungen führen könnte.
7. Remove the new developer cartridge from its protective bag.
8. Grasp the green latches at each end of the new developer
cartridge and raise them straight up to open them.
9. Holding the new developer cartridge by the green latches,
gently lower it into the empty slot until it is securely in place
(fig. 2.7).
10. Close the cartridge latches by pushing them down (fig. 2.8).
11. Grasp the green tab attached to the top of the developer
cartridge. Then, pull the tab and attached clear tape straight
up and out of the cartridge, and discard it (fig. 2.9).
12. Replace the toner cartridge that you removed in step 2.
13. Replace the printer’s top cover.
14. Clear the
x DEV LOW
message through the control panel
using the Administration/Engine/Clear Warning menu. See
chapter 4, “Printer Configuration,” for details on using the
control panel.
Replacing the OPC Belt Cartridge
This section covers replacing the OPC (Organic Photoconductor)
belt cartridge in your printer. See “How Your Printer Works” in
appendix D for details on what part the OPC belt plays in printing.
Chapter 6
C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e 6 - 9