QMS 1800409-001A, User Manual

Page: 311 / 436

8. Type the following command to extract the PCL 5 fonts file
to your PC’s hard disk:
a:af2pclfn
↵
9. At the DOS C:\QMSSYS prompt, type the following
command to make sure these files are in the QMSSYS
directory: SYSTEM.DL, AF2PSFN1.DL, AF2PSFN2.DL,
and AF2PCLFN.DL:
dir
↵
10. Turn the printer off and then on again. The following message
displays in the window:
QMS SOFTLOAD x.x
READY TO BOOT
11. Immediately press the Select key (before this message
disappears). When you press the Select key, the following
message appears in the message window:
QMS SOFTLOAD x.x
BOOT SYSTEM
NOTE: If 10 seconds passes before you press the Select key,
the
IDLE
message appears, and you must return to step 2.
12. Press the Next key until INSTALL TO DISK appears on the
second line of the message window:
QMS SOFTLOAD x.x
INSTALL TO DISK
13. Press the Select key to enter the Install to Disk submenu. Then
press the Next key until the name of the communication port
you’re using appears in the second line of the message
window, for example:
INSTALL TO DISK
PARALLEL
Chapter 8
P r i n t e r O p t i o n s 8 - 5 5