Qlogic QConvergeConsole CLI 8100 Series, User Manual

Page: 335 / 348

B–Cisco Nexus 5000 Series Switch Configuration
Create and Configure the VLAN
FE0254601-00 A B-3
3. Save the current configuration to the switch nonvolatile memory, and then
exit configuration mode by issuing the following commands:
(config)# copy running-config startup-config
(config)# exit
4. Reboot the switch by issuing the following command:
# reload
The switch may take several minutes to reboot.
5. When the reboot is complete, log in to the switch as the administrator.
6. Confirm that the FCoE function is enabled by issuing the following
command:
# show feature
Create and Configure the VLAN
To create and configure the VLAN:
1. Enter the switch configuration mode by issuing the following command:
# configure terminal
2. Create the VLAN interface 1002 by issuing the following commands:
(config)# vlan 1002
nexusmv1(config)# vlan 1002
3. Enable FCoE for the VLAN, and create a mapping from this VLAN to a
VSAN by issuing the following command:
(config)# fcoe vsan 1
Configure the Physical Ethernet Interface Switch
Port
To configure the physical Ethernet interface switch port to which the QLogic 8100
Series Adapter is connected:
1. Enter the interface configuration mode for the CEE switch port that connects
to the QLogic Converged Network Adapter by issuing the
interface ethernet
command. In the example, the QLogic adapter is
connected to the Cisco Nexus FCoE switch port 1/19.
(config)# interface ethernet 1/19