Qlogic QConvergeConsole CLI 8100 Series, User Manual

Page: 117 / 348

4–Installation in a Linux Environment
Verifying the Driver Installation
FE0254601-00 A 4-19
Verifying the Driver Installation
Verify every adapter to guarantee that the FCoE and networking adapter drivers
have been installed successfully and operational. To verify the driver installation:
1. Use the lsmod command to list the loaded kernel modules, and then locate
the QLogic FcoE (qla2
xxx ) and networking (qlgc) driver entries.
 The following example lists kernel modules for the QLogic FCoE driver.
# lsmod | grep qla2xxx
qla2xxx 1133797 3
scsi_transport_fc 73800 1 qla2xxx
scsi_mod 196697 8 scsi_dh,sr_mod,sg,lbata,
qla2xxx, scsi_transport_fc,sd_mod
 The following example lists the kernel modules for the QLogic
networking driver.
# lsmod | grep qlgc
# qlge 129881 0
#
2. Verify the QLogic adapter driver versions. You can use sysfs (FCoE) and
ethtool (networking), which is usually the most accurate. You can also use
the modinfo command.
 The following example displays the FCoE driver version, where X is
the sysfs host number for the FCoE driver.
# cat /sys/class/scsi_host/host X /driver_version
8.03.01.06.05.06-k
#
 The following example displays the networking driver version, where
eth0
specifies the network interface associated with the adapter
networking function.
# ethtool –i eth0
driver: qlge
version: 1.00.00.23
firmware-version: v1.35.11
bus-info: 0000:85:00.0
The
modinfo
command displays vendor and version information the about
Linux kernel modules.