Qlogic QConvergeConsole CLI 8100 Series, User Manual

Page: 257 / 348

8–Configuring FCoE in a Linux Environment
FCoE Driver Parameters for Linux
FE0254601-00 A 8-3
Interrupt Delay Timer The time interval, in 100ms
increments, between the
response queue update and
the interrupt generation.
This parameter can be speci-
fied only if the Operation Mode
parameter is enabled. Other-
wise, this parameter is set to
zero. This parameter should
be set to zero unless the Oper-
ation Mode parameter is set to
5 or 6.
The interrupt is not generated
if the host updates the
Response Queue Out-Pointer
Register during this interval.
The default is zero, which cor-
responds to an interval of two
hours. 0 0–255 Fast!
UTIL,
QConverge-
Console GUI,
or QConverge-
Console CLI
Spin-up delay Time that the adapter port
waits before scanning the
channel for devices. 0 0–2 seconds Fast!
UTIL
Frame Size Maximum frame length of a
Fibre Channel frame created
by that adapter for encapsula-
tion in an Ethernet frame. 2,048 512, 1,024,
2,048 Fast!
UTIL,
QConverge-
Console GUI,
or QConverge-
Console CLI
Enable hard loop ID Enables or disables the
adapter hard loop ID on the
Fibre Channel bus. This
parameter may be necessary
on some bus configurations
when devices do not appear. 0 0—Disabled
1—Enabled QConverge-
Console CLI
Enable extended error
logging Enables or disables the log-
ging of driver-detected events
that occur in the driver or the
Fibre Channel bus. 0 0—Disabled
1—Enabled modprobe
Table 8-1. FCoE Driver Parameters for Linux
Parameter Description Default Range
Configuration
Method