Avoid any urgent or sudden braking, otherwise it
will make the motorcycle slide or overturn
Carefully apply force to the brake so as to prevent any
motorcycle direction deviation, improper braking will
cause motorcycle sideslip.
Train rails, iron plates used for road construction
and manhole covers are especially slippery when they
Engine running-in
Nothing is more important than the 0
～
1000 kilometers
for a new motorcycle at any of its operational stages.
Based on this reason,we recommend you to read carefully
the information below. As the engine is new, you must
be able to avoid any overload of the engine in initial
1000 kilometers driving. Each of the components inside
the engine needs an interactive running-in for a certain
length of running time. Therefore, in this period, try to
avoid any full throttle valve operation for a long time
or any occurrence of the conditions that will cause
overheating of the engine.
1. 0-150 kilometers prevent the engine from continuous
running with the throttle grip turned above 1/3 throttle
travel. Each time when the engine has run for 1 hour, stop
the engine and allow it to cool for 5 to 10 minutes and
drive your motorcycle with frequent change of speed.
vehicles, and switch on the turn signal lamp before
getting going.
4.
Turn slowly the throttle grip and make the motorcycle
start. After making the starting, turn off the turn signal
lamp.
Before first operating of a new motorcycle, please read the
instructions in section"Running-in of the Engine"
(page 14).
Acceleration
Turn the throttle grip to adjust the running speed. When
turning the throttle grip towards yourself you can increase
the speed, and when turning in the reverse direction,
you will lower the speed.
Braking
1. Release the throttle grip.
2.
Apply force slightly to the front and rear brake and
then slowly increase the applied brake pressure.
Notice
are wet,therefore drive with special care while passing
these locations.
Braking on a wet road surface will lead to a very poor
braking effect and braking distance will be lengthened,
it is very danger.
It will be also dangerous if braking is made on a road
surface with a slope. Slowly apply braking force to the
brake while running on a downward slope.
USER'S MANUAL
14
