MAIN POINTS FOR MOTORCYCLE USING AND
RIDING
Before riding this motorcycle, make sure that you are
fully familiar with each of the operation controls and
functions of the motorcycle. Should there be any item
that you do not fully understand, contact your dealer
from whom the motorcycle was originally purchased
or the appointed maintenance station.
Never start your engine at any enclosed places, as the
exhaust gas of the motorcycle discharges has toxicity
and will make you lose consciousness and even cause
death. Therefore, make sure to operate your motorcycle
at a well-ventilated place.
Make sure that you have retracted the side stand before
riding, or you will not be able to start your vehicle.
Engine starting and pre-warming
1.Turn the main switch to " ".
2.While grasping the front brake or rear brake lever, hold
the throttle grip for a little wide opening of the throttle
(1/8 throttle travel or 1/4 throttle travel), press starting
switch or tread the starting lever to start the engine.
Before starting the engine , make sure that the side
If the engine can not be started even when the starting
button has been pressed 4-5 times, turn the throttle
rotate handle with a 1/8, 1/4 throttle travel and then
press the starting button again.
Engine pre-warming
In order to extend the engine's used life, pre-warm the
engine for 1-3 minutes before riding your motorcycle,
but never try swift acceleration in a cold engine state.
Starting of the motorcycle
After the engine pre-warming:
1. Hold the rear holder of the motorcycle by right hand
and push the motorcycle forward to make the main
stand spring up.
2. Before starting the motorcycle, check the rearview
mirror angle and make sure you can see clearly the road
surface condition at your back.
3. Pay attention to the traffic status for coming and going
Warning
Note
stand has been back to its up position .
In case of a failure to start the engine, release the starting
switch, and try again after a few seconds.The time for
starting the engine should not exceed 5 seconds every
time when you start the engine so as to avoid large
consumption of battery power. In case of a failure to
start the engine with the starting switch,start the engine
by starting lever instead.
USER'S MANUAL
13
