q-Tech QSW-9010, Cli Configuration Manual

Page: 80 / 101

User Manual
7. ACL service configuration 80
www.qtech.ru
The ACL rule does not support multicast MAC address.
7.4. ACL Action Configuration
Figure 7-3 ACL Action Configuration
7.4.1. Packet-Filter
The packet-filter command is used to configure the ACL filtering rule for the specified port and enable
it. Use this command when you need to filter the data flow at a port with ACL rules. When the filter
rule is configured successfully, the system will filter the input or output packets of the specified port
according to the rule.
OLT (config) # packet-filter ingress ACL 2222 rule 1 port gpon-olt1
/ 11
The "no packet-filter" command is used to cancel the ACL filter rule for the specified port. Use this
command when you need to delete the ACL filter rule for the specified port.
OLT (config) # no packet-filter ingress ACL 2222 rule 1 port gpon-
olt1 / 11
7.4.2. Traffic-Limit
The "traffic-limit" command is used to limit traffic where messages match the ACL filtering rules
received by the specified port. Use this command when you need to have rate limitations on a port
that matches the ACL rule. After the flow limit configuration is successful, if the port receives more
traffic than the limit, it will directly discard the message over the restricted part or reset the DSCP
priority to the message in excess of the limit.
OLT (config) # traffic-limit ingress ACL 2222 rule 1 rate 640000
drop port gpon-olt1 / 11