q-Tech QSW-9010, Cli Configuration Manual

Page: 18 / 101

User Manual
1. GPON properties 18
www.qtech.ru
1.9.4. Delete User
OLT (config)# no username 111
1.10. Trap Configuration
Set the IP address of the destination host for the Trap message. When the IP address of the host of
the Trap message destination is successfully set, the Trap message of the device will be sent to the
host corresponding to the IP address when the Trap message is enabled.
Enable:
OLT(config)# snmp-server trap enable
Rights:
OLT(config)# snmp-server community rw trap
OLT(config)# snmp-server syscontact contact
OLT(config)# snmp-server syslocation location
OLT(config)# snmp-server sysname sysname
SNMP Version:
OLT(config)# snmp-server trapsink 192.168.17.117 //v1
OLT(config)# snmp-server trap2sink 192.168.17.117 //v2
SNMP encryption:
OLT(config)# snmp-server user rw username v3 md5 password aes
privacy
Note:
The SNMP version of the OLT network element configuration is permanent, and cannot be deleted. The
SNMP version of the network element configuration cannot be deleted and modified by the network
administrator. Please configure the SNMP related content by using the NMS network management.
OLT network management (NMS) does not need to configure trap again at the network element interface
when using the trap configuration.
1.11. CPU&Memory View
OLT can view the current CPU user status and the kernel, memory user status and the occupancy rate
of the kernel.
OLT# show processor
Total %CPU(user/kernel): 10.5/2.8
Total %Mem(user/kernel): 33.9/0.488