q-Tech QSW-9010, Cli Configuration Manual

Page: 37 / 101

User Manual
4. Unicast service configuration 37
www.qtech.ru
-------------------------------------------
0018-7d9d-2ffb 17 xe1 /
2 dynamic 00e0-
4c60-7348 17 xe1 / 2 dynamic 28a0-
2b2b-821e 17 xe1 / 2 dynamic 3891-
d5ad-9678 17 xe1 / 2 dynamic c4ca-
d930-de0d 17 xe1 / 2 dynamic 0000-
0400-0001 100 gpon-onu1 / 5: 5 dynamic
0000-0500-0001 100 xe1 / 1 dynamic
c4c9-ec10-cfd1 100 gpon-onu1 / 5: 5 dynamic
60e6-bc00-3554 200 gpon-onu1 / 5: 2 dynamic
total: 9
4.2.1.6. The uplink port broadcast storm-control
OLT supports the rate limit for broadcast, multicast, and unknown unicast packet. There are two rate
limit ways: Kbps and PPS of packets, which are effective for incoming packets.
OLT (config-xe1 / 1) # storm-control broadcast pps 10000
OLT (config-xe1 / 1) # storm-control multicast pps 10000
OLT (config-xe1 / 1) # storm-control unicast pps 10000
OLT (config-xe1 / 1) # storm-control broadcast kbps 10000
OLT (config-xe1 / 1) # storm-control multicast kbps 10000
OLT (config-xe1 / 1) # storm-control unicast kbps 10000
Note:
When configured as Kbps, the rate limit is more accurate when the configuration value is
200kbps~100Mbps;
When the rate limit PPS is between 1~4, there will be some fluctuation
4.2.1.7. Monitor session
The feature copies the packet of the designated port to the port connected to the data monitoring
device so that the user can monitor and analyze the copied messages for network monitoring and
troubleshooting.
The source port xe1/2 is mirrored into the destination port xe1/1:
OLT (config) # monitor session 1 ingress destination xe1 / 1 source
xe1 / 2
OLT (config) # show monitor
Session Source port Destination port Type Vlan
1 xe1 / 2 xe1 / 1 ingress –