q-Tech QSW-9010, Cli Configuration Manual

Page: 12 / 101

User Manual
1. GPON properties 12
www.qtech.ru
Note:
Out-band and In-band management IP address can not be in one network segment.
We suggest configure only one in-band management IP. If more IP are configured, other will not be
able to connect to the network, but can connect to PC by configuring PVID.
Configure in-band Gateway:
OLT(config)#gateway 10.1.1.254
Note:
can only configure one gateway, the previous configuration should be deleted if you want to change.
Change in-band IP and Gateway:
Note:
If you want to delete IP, please delete the gateway before deleting IP, and add new address again.
OLT(config)#no ip address vlan 1000
OLT(config)#no gateway
Save Configuration Data:
OLT(config)#exit OLT#write
Check in-band management:
OLT(config)# show managment vlan
management vlan 10 ip address 192.168.1.32/24
management vlan 18 ip address 192.168.18.188/24
1.5. Configure NTP system time synchronization
NTP (Network Time Protocol) network time protocol is at application layer, which is used to
synchronize time between distributed time server and clients, and is based on IP and UDP. NTP
protocol is evolved from time protocol (Time Protocol) and ICMP timestamp message, with special
design for better accuracy and robustness.
Sets access control rights for the local device NTP service. To protect the local NTP service, you can
use this command to set access rights to the local NTP service. When the command is configured
successfully, after the NTP synchronization message is received, the local device will determine
whether the message needs to be processed according to the authority of the configuration and the
content of the message, and whether to allowed to synchronize with the device. When OLT works in
the NTP client mode, it will keep time synchronization with the NTP server.
Enable NTP functionality in global configuration mode:
OLT(config)#sntp enable