HYD-2100.
CNC Plasma&Flame Cutting Control System
Edition of 28.07.2015
41
www.purelogic.ru
8 (800) 555 63 74
F1 Input
F2 Output
F8 Save
Definition of input
Forward limit
02
Back limit 15
Left limit 14
Right limit 01
Sharpstop 03
ArcFeedback 04
PosFeedback 05
PlasmaCrash 06
Up move input 09
Down move input 10
Left move input 07
Right move input 08
Acceleration input 16
Deacceleration input 17
Torch up input 18
Torch down input
19
F3 Axes
F4 Motor
Port Type
Port Type
Port- Press PgUp/PDn
Type-Press Enter
F1 Input
F2 Output
F8 Save
Definition of input
Forward limit
02
Back limit 15
Left limit 14
Right limit 01
Sharpstop 03
ArcFeedback 04
PosFeedback 05
PlasmaCrash 06
Up move input 09
Down move input 10
Left move input 07
Right move input 08
Acceleration input 16
Deacceleration input 17
Torch up input 18
Torch down input
19
F3 Axes
F4 Motor
Port Type
Port Type
Port- Press PgUp/PDn
Type-Press Enter
F1 Input
F2 Output
F8 Save
Definition of output
Ignition
03
LowPreheat 01
HighPreheat 17
LowOxygen 04
MidOxygen 05
HighOxygen 14
TorchUp 02
TorchDown 15
Exhaust 06
THC 08
PosDetect 19
ArcStart 16
LowSpdInCorner 18
Dust spray 07
Raise dust 20
Dust preheat
21
F3 Axes
F4 Motor
Port Type
Port Type
Port- Press PgUp/PDn
Type-Press Enter
F1 Input
F2 Output
F8 Save
Definition of output
Ignition
03
LowPreheat 01
HighPreheat 17
LowOxygen 04
MidOxygen 05
HighOxygen 14
TorchUp 02
TorchDown 15
Exhaust 06
THC 08
PosDetect 19
ArcStart 16
LowSpdInCorner 18
Dust spray 07
Raise dust 20
Dust preheat
21
F3 Axes
F4 Motor
Port Type
Port Type
Port- Press PgUp/PDn
Type-Press Enter
Figure 52. Input definition
Figure 53. Output definition
Output definition
The controller could change the IO definition, including changing the order of IO number, the type of IO (normally open or closed) according to the user’s
need. In the system custom definition interface, press F3 to enter the definition interface, press F1 to enter the input definition interface.
As shown in fig. 53.
In the interface press [↑], [↓], [←], [→], move the cursor to the position that needs changing, press [PageUp], [PageDown] to change the number of the
Output, press [Enter] to change the type of the Output.
The output type is open drain transistor output type. Type means that if the output signal is effective, the transistor is on. Type means that is
the output signal is effective, the transistor is off.
Coordinate definition
The system could provide IO definition for the user. As shown in Fig. 54.