Pulsar Measurement Ultra 3, Instruction Manual

Page: 35 / 179

PULSAR MEASUREMENT
35
Hot Keys
There are five hot keys on the keypad, which can be used to quickly access
common parameters for viewing only, while in Run Mode. Pressing the hot
key once will display the first parameter, then repeated pressing will display
the others, then the Ultra 3 reverts to Run Mode. In program mode, they
have different functions, the functions are shown below.
HOT KEY RUN MODE PROGRAM MODE
When application is Flow, view non-
resettable totaliser. View and reset the
resettable totaliser.
Not used with Ultra 3
Displays echo confidence, echo
strength, height above loss limit (HALL),
average noise, peak noise and
temperature
Not used with Ultra 3
Not used with Ultra 3
Reset parameter to default
setting
Instantaneous mA output Not used with Ultra 3
Dependent on application. Displays
distance, level, space, volume or rate of
change of level. Toggle relay setpoints
between units of measure and
% of span.
Not used with Ultra 3
Takes you to the last
parameter edited when you
first enter program mode.
Shows details of function type, firmware
revision and serial number
Enter decimal point.
∑
mA
n