Protech Systems PA-6822, User Manual

Page: 108 / 250

Chapter 3 Software
ESC c 4 n
[Name] Select paper sensor(s) to stop printing.
[Format]
ASCII ESC c 4 n
Hex. 1B 63 34 n
Decimal 27 99 52 n
[Range]
Specification: 0
≤
n
≤
3
Initial Value n = 0
[Description]
Selects the paper out detector to stop printing when paper has run out.
Bit Function
〝
0
〞 〝
1
〞
7 Undefined
6 Undefined
5 Undefined
4 Undefined
3 Undefined
2 Undefined
1 Paper roll near end detector Invalid Valid
0 Paper roll near end detector Invalid Valid
ESC c 5 n
[Name] Enable/disable panel buttons
[Format]
ASCII ESC c 5 n
Hex. 1B 63 35 n
Decimal 27 99 53 n
[Range]
Specification: 0
≤
n
≤
255
Initial Value n = 0
[Description]
Toggles the panel switches between enabled and disabled.
Enables panel switches when n = <*******0>B.
Disables panel switches when n = <*******1>B.
n is effective only when it is the lowest bit.
When disabled, all panel switches are disabled.
ESC d n
[Name] Print and feed n lines
[Format]
ASCII ESC d n
Hex. 1B 64 n
Decimal 27 100 n
[Range] 0
≤
n
≤
255
[Description]
Prints the data in the print buffer and performs a paper feed of n lines.
Sets the print position to the beginning of the next line after printing.
Paper is fed approximately 150 mm if the [n x basic calculated pitch] exceeds
approximately 150 mm (5.9 inches).
ESC i
[Name] Full cut.
[Format]
ASCII ESC i
Hex. 1B 69
Decimal 27 105
[Range] N/A
[Description] This command executes a full cut of the paper in standard mode
PA-6822 Series User Manual Page