Protech Systems PA-6822, User Manual

Page: 105 / 250

Chapter 3 Software
ESC S
[Name] Select standard mode
[Format]
ASCII ESC S
Hex. 1B 53
Decimal 27 83
[Range] N/A
[Description]
Valid only when input by page mode.
All buffer data in page mode is deleted.
Sets the print position to the beginning of the next line after execution.
The print area set by ESC W (Set print region in page mode) is reset to the
default setting.
This command switches the settings for the following commands the values of
which can be set independently in standard mode and page mode to those for
standard mode
a. ESC SP :Set character right space amount
b. FS S :Set Chinese character space amount
c. ESC 2 :Set default line spacing
d. ESC 3 :Set line spacing
The following commands are effective only when in standard mode.
a. ESC W :Set print region in page mode
b. ESC T :Select character print direction in page mode
The following commands are ignored in standard mode.
a. GS $ :Specify absolute position for character vertical direction in page mode
b. GS \: :Specify relative position for character vertical direction in page mode
Standard mode is selected when the power is turned on, the printer is reset or
initialized (ESC @).
ESC T n
[Name] Select print direction in page mode.
[Format]
ASCII ESC T n
Hex. 1B 54 n
Decimal 27 84 n
[Range]
0
≤
n
≤
3, 48
≤
n
≤
51
Initial Value n = 0
[Description]
Selects the character printing direction and starting point in page mode.
n Print Direction Starting Point
0, 48 Left to Right Upper Left (A in the figure below)
1, 49 Bottom to Top Lower Left (B in the figure below)
2, 50 Right to Left Lower Right (C in the figure below)
3, 51 Top to Bottom Upper Right (D in the figure below)
PA-6822 Series User Manual Page