Protech Systems PA-6822, User Manual

Page: 107 / 250

Chapter 3 Software
ESC \ nL nH
[Name] Set relative print position.
[Format]
ASCII ESC \ nL nH
Hex. 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0
≤
(nL + nH x 256)
≤
65535 (0
≤
nL 255, 0
≤
nH
≤
255)
[Description]
Specifies the next print starting position with a relative position based on the
current position. This sets the position from the current position to [(nL + nH x
256) x basic calculated pitch] for the next print starting position.
Specifications exceeding the print range are ignored..
ESC a n
[Name] Select justification.
[Format]
ASCII ESC a n
Hex. 1B 61 n
Decimal 27 97 n
[Range]
0
≤
n
≤
2
Initial Value n = 0
[Description]
This command specifies position alignment for all data in one line in
standard mode, using n as follows:
n Alignment
0 Left alignment
1 Center alignment
2 Right alignment
This command has no effect in page mode.
ESC c 3 n
[Name] Select paper sensor(s) to output paper-end signals.
[Format]
ASCII ESC c 3 n
Hex. 1B 63 33 n
Decimal 27 99 51 n
[Range]
Specification: 0
≤
n
≤
3
Initial Value n = 0
[Description]
Selects paper out detector that outputs a paper out signal when paper has
run out.
Bit Function
〝
0
〞 〝
1
〞
7 Undefined
6 Undefined
5 Undefined
4 Undefined
3 Undefined
2 Undefined
1 Paper roll near end detector Invalid Valid
0 Paper roll near end detector Invalid Valid
PA-6822 Series User Manual Page