![background image](http://html.mh-extra.com/html/promise-technology/vtrak-s3000/vtrak-s3000_quick-start-manual_1617268008.webp)
VTrak S3000 Quick Start Guide
8
Task 3: Configuring the VTrak Appliance
VTrak appliance configuration is done through the PROMISE Management
Console over a network connection. This process takes about 15 minutes.
When you add the VTrak appliance to your network, be sure the Host PC, where
you plan to run the Management Console, can connect with the VTrak appliance
over the network.
Before you begin configuration, obtain four
dedicated
IP addresses from your
Network Administrator:
•
Ethernet port 0 (eth0)
•
IPMI LAN
•
Heartbeat
•
Health Monitor
Making Power and Network Connections
To make power and network connections on the appliance:
1.
Plug the power cords into power supplies.
2.
Attach at least one active LAN cable to one of the network ports.
3.
Attach an active LAN cable to the IPMI port.
See Figure 6 for an example.
Figure 6. VTrak appliance setup connections
Accessing the Power Button
To access the power button and boot the VTrak appliance:
1.
Unlock the bezel.
2.
Push the bezel release tab to the left to release the bezel. See Figure 7.
3.
Remove the bezel and set it aside.
4.
Press the power button to boot the VTrak appliance.
See Figure 8.
2 4 8
TX RX
TX RX
8 4 2
2 4 8
TX RX
TX RX
8 4 2
IPMI LAN port
1 Gb/s Heartbeat port
Power supplies
1 Gb/s Management port