n
etwOrk
S
ettingS
Configure network settings for the different interfaces, for the
Public
,
Cluster (private)
and Management
networks.
It is only necessary to set IP settings for one Management port (
eth0
), but you can configure all the 1G ports
if you wish. Just make sure they are all on the same subnet, and separated physically from the other networks.
Note that the IP settings for the eth0 port are used for administration using the web GUI.
Later you will need to configure these same network settings for any nodes that will be added to the cluster.
The steps required for creating the network settings are summarized as follows:
1. Configure Bonding
2. Configure Network Interface
3. Configure NTP Server
35
Initial Setup
Promise Technology, Inc.
